Manufactured by Miles Industries Ltd., British Columbia, Canada
33
d) For active remote control with active appliance switch
Caution! Don’t connect the batteries in the remote control receiver until the wires are
connected to the burner control unit. A short circuit could result in destruction of the
electrical components.
A set of four batteries and battery box is supplied with the appliance and a further set with the
remote control unit. Only one set is required. The other set can be kept by the owner as spares.
Figure 60a
•
Feed the switch wires through the switch opening in the surround.
•
Cut off the “L” terminals from the switch wires
on the remote control receiver
and remove
insulation from approximately ¼” at ends of wires. See figure 60a.
•
Securely connect the wires to the terminal block.
Connect
the black wire to the terminal opposite the brown wire.
Connect the wire with the white stripe to the terminal
opposite the yellow wire.
See figure 60b.
•
Route the wires round the back of the valve and connect the
“L” terminals to the control unit.
•
Remove the remote control receiver lid. Remove the cover
from the
white
connection pad. Fit this connection pad to the
remote control receiver terminals. See figure 60c.
•
Fit the
black
connection pad to a battery box. Fit four 1.5V
batteries. See figure 60c.
Figure 60b
•
Place the batteries and connection pad in the receiver box and
replace the lid.
Figure 60c
Fit the 9V battery to the handset transmitter.
4. Refit the battery shield with the two screws previously
removed – Figure 61.
This shield is not needed if wall switch is
installed.
5.
Unless fitting wall switch
, place the battery box or remote
control receiver on the “Velcro” pad in front of the battery shield.
See figure 62.
Figure 61
Figure 62
