5.2.9.
Top vent connection, vertical vent rise with
horizontal rear termination (Fig.29)
Figure 29
Can be used with either #551DVK standard vent kit or #984
Dura-vent terminal cap and accessories.
Adapter #817VAK, two 45° elbows #945B, one 90° vent elbow
#990B and Dura-vent pipe lengths will be required.
(See venting options section of this manual).
The location requirements are (See figure 29):-
Minimum Maximum
A
: From floor to top of
vent duct
4ft 1
1
/
2
”
(126cm)
12ft 1
1
/
2
”
(370cm)
B
: Surround front to
outside wall
- 5ft
8
7
/
8
”
(175cm)
C
: Surround front to
inside wall
15
7
/
8
” (40cm)
-
D
: Vertical pipe run
0”
8ft (244cm)
E
: Horizontal pipe run
-
4ft 6” (137cm)
F
: Clearance to
combustible materials
above horizontal pipe
run
2
5
/
8
” (6.7cm)
-
G
: Clearance to
combustible materials
below horizontal pipe
run
1
5
/
16
” (3.3cm)
-
H
: Clearance to
combustible materials
all round vertical pipe
run and at sides of
horizontal pipe run
1
5
/
16
” (3.3cm)
-
Figure 30
5.2.10.
Top vent connection, vertical
vent rise with horizontal side
termination (Figs.29 &30)
Can be used with either #551DVK standard
vent kit or #984 Dura-vent terminal cap and
accessories.
Adapter #817VAK, two 45° elbows #945B,
one 90° vent elbow #990B and Dura-vent pipe
lengths will be required.
(See venting options section of this manual).
All vertical dimensions and clearance limits are
as section 5.2.9.
The minimum floor location is shown in figure
30.
5.2.11.
Top vent connection, vertical
vent rise with horizontal side or
rear snorkel termination
The dimensional requirements in sections 5.2.9
and 5.2.10 apply.
Adapter #817VAK, two 45° elbows #945B, one 90° vent elbow #990B and Dura-vent pipe lengths will be required.
#942 Dura-vent thimble kit may also be necessary.
(See venting section of this manual).
Manufactured by Miles Industries Ltd., British Columbia, Canada
17
