![background image](http://html1.mh-extra.com/html/v-tek/versacount-ii/versacount-ii_user-manual_3083341032.webp)
22
Versacount II+ User’s Guide
Counting SMD Reels with an EPD
61673621.fm
Pressing the ESC key will exit the Run screen and return to the Setup screen. This will reset the
count to zero (0); therefore, this should not be done unless the count is complete or being
restarted.
Stopped Screen
When the counter stops after counting has
begun, the Stopped Screen will be displayed.
This could occur because the stop count has
been reached or the operator has stopped the
counter and the carrier has not moved for more
than three seconds. The screen will appear in
one of two ways, depending on the options
installed as shown in Figure 1-35.
The counter will remain in Run mode and continue counting while stopped. The operator can
turn the reels manually to reach an exact count, if desired. Alternatively, pressing STOP/GO will
cause the counter to resume transferring the reel.
The Stopped Screen also displays the direction arrow, the current parts count, and the empty
pocket count. If the empty pocket detector is disabled, EPD=off will appear instead of a count of
empty pockets detected. When this screen is displayed, the operator can change the counting
direction by pressing the left or right arrow key.
If the reel count is complete, the operator can choose to press 5 on the keypad to send the parts
and empty pocket count data to an hardware option that may be currently enabled. If this is not
desired, pressing the ESC key will clear the current counts and return to the Setup Screen.
The “5=” message will appear if a hardware option is installed and enabled and will depend on
the hardware option that is installed. In Figure 1-35, the label printer option is enabled. If the PC
option is enabled, the message will read 5=SEND TO PC.
5=Send to PRINTER ESC=Back
COUNT=1 ->
Figure 1-35
STOP/GO=RUN ESC=Back
COUNT=1 ->
Summary of Contents for Versacount II+
