Appendix B Expansion Memory
B-2
DIMMs to be used
See your dealer for purchasing information of the
DIMMs that are best suited for use with this printer. 16 MB, 32
MB, 64 MB, and 128 MB DIMMs can be used for memory ex-
pansion.
Insert the DIMM into the socket as shown below.
Remove the DIMM from its package.
Open the clips on both ends of the DIMM socket.
Insert the DIMM into the socket, so that the notches on
the DIMM align with the corresponding protrusions in
the socket.
Close the clips of the DIMM socket to secure the
DIMM.
When you finish installing the DIMM, reinsert the main
circuit board into the printer by reversing the removal
procedure.
To remove a DIMM, carefully pull the end clips outwards, then
pull the DIMM out of the socket.
Return the main circuit board to the printer by reversing the pro-
cedure explained in
Removing the Main Circuit Board from the
Printer on page B-1
.
After you finish installing DIMMs in the printer, test the printer to
see if the installation was successful. To test the expansion
memory, proceed as follows:
Make sure printer is turned off. Plug the power cord
into the printer and turn the printer on.
Press the
MENU
key on the operator panel.
Press the
3
or
4
key repeatedly until
Print Status
Page
appears.
Press the
ENTER
key twice.
If the installation was successful, the amount of memo-
ry shown on the status page will correspond with the
amount of expanded memory. (The factory installed
memory size is 32 MB.)
2. Installing DIMMs
1
2
3
4
5
2.1 Removing DIMM
2.2 Testing the Expansion Memory
1
2
3
4
5
Summary of Contents for LP 3036
