8
US Water UV Light Introduction
Ethernet
Module Check
Remote Alarm
Module Check
Once the controller has finished checking for the installation of all available modules a single screen is dis-
played showing which specific modules are installed and activated on this particular system.
Please Note:
If the corresponding module icon is not displayed on this screen, then that module is not installed on this
system. If you believe this module is installed correctly, recheck the applicable connections to ensure a
solid connection point and then restart the controller. The controller then continues to optimize the lamp
efficiency by waiting 60 seconds to allow the lamp to reach its optimum output. Finally, a final "start-up
complete" screen is displayed. These screens will appear as follows:
USWATER 5.0 Operational Screens
On USWATER5.0 systems (without the UV monitor), the default screen shows the
US Water Systems Home
Screen
. At an y point du ring operation the user is able to s croll throug h the
US Water Systems
Home Screen, Lamp life remaining
and
QR Code/Contact Info
screens by simply pressing the button
located on the front of the controller.
