DS1067-035A
80
LBT8633
5.11.2 Device address display
To verify the address of a specific system bus device follow the instructions below:
1. Enter on the keypad the Installer code and press
OK
key.
2. Press
MENU
key.
3. Press
▼
key until “MAINTENANCE” appears on the display.
4. Press
OK
key to confirm.
5. Press
▼
key until “SHOW ADDRESSES” appears.
6. Press
OK
key to confirm.
7. Select with
▲
and
▼
keys the device to be examined: EXPANSIONS, KEYPADS,
READERS or RADIO DEVICES. Confirm the selection with
OK
key.
8. Appears the address list of this device type, browse it with
▼
and
▲
keys.
9. Select the desired device and confirm with
OK
key.
10. “IN PROGRESS…” appears.
Consider all the installed devices: the device with the desired address will have the
acquisition yellow LED blinking. Press the acquisition key on the selected device to confirm
that the search has been successful and turn off the LED.
11. On the keypad where the installation started press
ESC
key repeatedly to exit from the menu.
5.11.3 Software release display
To know the software version in a bus device of the system (or of the control panel) follow the
instructions below:
1. Enter on the keypad the Installer code and press
OK
key.
2. Press
MENU
key.
3. Press
▼
key until “MAINTENANCE” appears on the display.
4. Press
OK
key to confirm.
5. Press
▼
key until “SW. REL” appears.
6. Press
OK
key to confirm.
7. Select with
▲
and
▼
keys the device to be examined: CONTROL PANEL, EXPANSIONS,
KEYPADS, READERS or RADIO DEVICES. Confirm the selection with
OK
key.
8. If CONTROL PANEL has been selected, it is possible to directly read the software version.
In the other cases it is necessary to select the desired device from a list (with
▼
,
▲
and
OK
keys) before reading the software version.
9. Press
ESC
key repeatedly to exit from the menu.
5.11.4 Partial
reset
With partial reset, all configurations of the system device, included control panel configurations, are
reset to factory settings. Codes, keys and event log are not deleted. To partially reset follow the
instructions below:
1. Enter on the keypad the Installer code and press
OK
key.
2. Press
MENU
key.
3. Press
▼
key until “MAINTENANCE” appears on the display.
4. Press
OK
key to confirm.
5. Press
▼
key until “PARTIAL RESET” appears and press
OK
key to confirm.
6. Press
OK
key to confirm or
ESC
key to undo the operation.
7. “IN PROGRESS...” appears on the display and the buzzer rings.
8. At the end of operation “MAINTENANCE” “PARTIAL RESET” appears again.
Now it is possible to program the system again.
UT00:INSTALLER
MAINTENANCE
MAINTENANCE
SHOW ADDRESSES
SHOW ADDRESSES
EXPANSIONS
EXPANSIONS
EPxx:EPxx
Epxx:EPxx
IN PROGRESS...
UT00:INSTALLER
MAINTENANCE
MAINTENANCE
SW. REL
SW. REL
CONTROL PANEL
CONTROL PANEL
REL. xx.xx
UT00:INSTALLER
MAINTENANCE
MAINTENANCE
PARTIAL RESET
PARTIAL RESET
ARE YOU SURE?
PARTIAL RESET
IN PROGRESS...
