DS1067-035A
73
LBT8633
5.4
DATE AND TIME CHANGING
Date and time stored in 1067/032 o 1067/042 control panel are used for the correct operation of the timing programmer
and to store events in the event log.
In order to change date and time shown on the display follow the procedure described in paragraph 4.4
TIME/DATE
SETTING.
5.5 EVENT
LOG
The event log stores the last 1000 events (arms, disarms, alarms, tampers, etc.) concerning the system.
Events are stored from the most recent to the oldest one, so the most recent event has the lowest identification number.
When a new event is added, all the stored events are shifted down of one position.
When the event log reaches the maximum dimension (1000 events), every new event to be stored causes the oldest
stored event deleting. The event log can be examined both by the Master user and other users.
Warning:
if the system has an areas configuration, the event log will be divided into equal parts among the
different users and every user can only read his own event data.
5.5.1
Read the Event log
To read the event log follow the instructions below:
1. Enter on the keypad the Master code (default 111111) and press
OK
key.
2. Press
MENU
key.
3. Press
▼
key until “EVENT LOG” appears on the display. Press
OK
key to confirm.
4. “SYSTEM” appears.
5. Press
OK
key to confirm.
6. Appear the 'list of the stored events', that is browsable with
▼
and
▲
keys. To understand
information on the display see paragraph 5.5.2
Meaning of event data.
7. After reading press
ESC
key repeatedly to exit from the menu.
5.5.2
Meaning of event data
In the event log an event is displayed as follows:
where
•
xxxx
is the event progressive number (0001 is the most recent event)
•
hh:mm
indicate event hour and minutes
•
dd/MM
indicate event day and month
•
<< Text >>
is the event description
According to the event type are available further information that can be displayed in cyclic mode by pressing
OK
key
one or more time. For example: bus device and user/key.
5.5.3 Event
log
deleting
Warning
: Event log deleting operation is not reversible!
To delete the Event log follow the instructions below:
1. Enter on the keypad the Installer code (default 000000) and press
OK
key.
2. Press
MENU
key.
3. Press
▼
key until “EVENT LOG” appears on the display. Press
OK
key to confirm.
4. “SYSTEM” appears.
5. Press
OK
key to confirm.
6. Press
▼
key until “ERASE EVENT LOG” appears on the display. Press
OK
key to confirm.
7. “ERASE EVENT LOG IN PROGRESS...” appears on the display and the event log is
deleted.
8. After deleting, press repeatedly
ESC
key to exit from the menu.
UT01:MASTER
EVENT LOG
EVENT LOG
SYSTEM
SYSTEM
READ EVENT LOG
0001 10:47 22/08
VALID CODE
xxxx hh:mm dd/MM
<< Text >>
UT01:INSTALLER
EVENT LOG
EVENT LOG
SYSTEM
SYSTEM
ERASE EVENT LOG
ERASE EVENT LOG
IN PROGRESS...
