50
DS1061-036A
5.5
SYSTEM CONFIGURATION VIA SOFTWARE
Using a PC provided with Urmet EasyPro software, it is possible to program more easily
1061/006A
control
panel
.
To do it, connect
the PC to the control panel via the USB 2.0 interface. With the same software it is
possible to access to further PSTN telephone communicator and GSM module configuration parameters. In
this way it is possible to perform a more detailed customization than the one obtained with the control panel
programming menus.
5.5.1
USB interface mounting and pc connection
To mount the USB interface and connect the PC, follow the instructions below:
1.
If necessary, put the system in maintenance mode, as described in paragraph
7.1
MAINTENANCE
PROCEDURE
2.
Connect the USB interface to the motherboard, as shown in the following diagram.
Figure 31 –
USB 2.0 interface connection diagram
3.
Connect the PC to the interface, using the provided USB cable.
At the end of the programming procedure, simply disconnect the USB interface from the control panel
motherboard.
WARNING
: I
t is assumed that the user is able to use the EasyPro software. For sections not
described in this manual (for example, the connection and its parameters, creation of a new system, etc.),
refer to the software user manual.
