digiset
5
Urma AG, Switzerland www.urma.ch
page 41
8 Imaging
For each measuring procedure ensure that the edges of the object to be
measured are not dirty because this could lead to incorrect measuring re-
sults.
8.1 Starting imaging
After it is switched on the Digiset 5 runs in accordance with the settings made in Op-
tions.
The object to be measured must be moved until it is in camera range and the contour
of the object, e.g. the tool cutting edge must be focussed sharply by turning the tool
on the tool support.
Procedure:
1. Move the object into the camera’s visual range.
2. If the relevant contour of the object is not clear, select the "Range" operating
mode and, using the mouse, make it the required size and drag it round the
relevant edge.
3. Turning the object to be measured on its support sets the greatest deviation
and thus the focus level.
4. While the object is being turned the test LED in the upper left corner turns
green as soon as the measurement is correct, i.e. the greatest deviation has
been determined. You must ensure here that the turning speed is not too
great.
It is vital here that the camera’s working distance has been set
correctly when commissioning the system (focussing).
If a counter module is connected the system waits for the reference marks of the
connected measuring systems to be transferred. The readings taken will be dis-
played directly after the reference trip.
8.1.1 Camera 2 (optional)
You access this operating mode using the following menu steps:
Main menu
Sub-menu 1
Imaging
Ö
2. Camera
If a second camera (e.g. incident camera) is used in the imaging system and both
cameras are attached to the TCAM2 via a camera switchbox, you can switch over to
the other camera using this operating mode.
)
