20
Version 1.612
9. If you have not set the Speaker Configuration, you must use the cursor controls to
enter the number
and type of speakers
in the clients system via the
Speaker Config
menu item.
10. Once the speaker configuration has been set for all speakers and subwoofers, using the
Up
cursor,
scroll up to select the top item on the menu above,
Auto Setup
and press the
Right
cursor key to
display the next menu.
11. Once the Auto Setup menu appears, use the
Down
cursor to scroll down to the
Start
item, then click
the
Right
cursor key to display the next menu. Make sure that all background sounds are eliminated,
and click the
Right
cursor key to start the measurement of all speakers.
Once the first stage is complete, you will be prompted to press the
Right
cursor again to measure
speaker crossovers. When this is complete, return to the previous menu. You’ll notice that the Room
EQ item shown in 9, is now active. If you select this, you can listen to the system with the calibration
EQ ON or OFF.
12. Returning to Accelerator, close
System Toolbox
and select
Apply
on the Zone 1 Settings window. This
will store all the measurements in Accelerator.
Programming DMS-AV in Accelerator
Program Menu: Step 8 DMS Setup/INPUTS/Configure (cont’d)
