The equipotential conductor must have a minimum sec-
tion of 10 mm2.
1- Ovens equipped with cordset and Schuko plug (single
phase 230V) or Nema pyug ) single pfare 120 or 230 v.):
is sufficient to insert the plug in the proper socket (the
socket must be suitable for the plug assembled in the
oven)
2- Ovens equipped with cordset (three phases 400V + Neu-
tral): these ovens are equipped with electrical cord with 5
conductors: it is necessary to connect the proper three-
phase 5 poles plug with suitable capacity or you can con-
nect the cord directly to the electrical panel.
In those ovens equipped with a cord with 5 conductors it
is possible to substitute the power cord to adapt the ap-
pliance to the available type of current.
To replace the power cord proceed as follows:
• Open the cover of the terminal board levering the two
lateral small wings with a proper screw-driver (1)
• Unscrew the screws that lock the conductors (2)
• Unscrew the screw that locks the cordstopper (3)
• Remove the supplied cord
• Connect the conductors that you would like to use ac-
cording to the chosen connection drawing; be sure to fix
properly the screws of the clamps.
• Block the cord using the proper cordstopper
• Close the cover of the terminal board.
WARNING:
Connect the electrical cable to the terminal board as shown on
the drawing: insert screw-wise the copper bridge and the elec-
trical cable together under the screw. Tighten the screw paying
attention that the cable and the copper bridge are well fixed
under the screw. A wrong connection can cause the overheat-
ing of the terminal board which can also melt.
FUMES EXIT FROM CAVITY
In the back side of the oven you find a fume chimney from
which the fumes that come from the cavity are ejected.
During each cooking cycle you will have hot and wet fumes
coming out from this chimney (temperature and humidity
of the fumes depend on the cooking parameters set on the
oven and on the type and quantity of food put inside the
oven).
The fumes that come out from the chimney can be guided
outside the room where the oven is installed or can be
condensated.
11. INSTRUCTIONS FOR
THE USER
The appliance cannot be cleaned with a jet of water.
Never wash the cavity with acids or aggressive detergen-
ts. Use only water and soap.
The appliance is made for a specific professional use and
must be used by qualified personnel only.
1. INSTRUCTIONS FOR THE OPERATOR
WARNING
: carefully read this user manual befo-
re starting to operate with the appliance as it gives
you important information regarding safety during
installation, use and maintenance of the appliance
itself.
Keep the manual in a safe place where the different opera-
tors that work with the appliance can easily find and read it.
Before using the appliance for the first time ensure that
inside the cooking chamber there are no instruction man-
uals, plastic bags or any other objects.
The appliance is not intended to be used by persons with
reduced mental, physical and sensory capacities (children
included), or without any expertise and know-how, un-
less they are informed about how to use the equipment
or they operate under the supervision of who is respon-
sible for their safety.
Children should be watched to make sure they do not
play with the equipment.
For any eventual repair, please apply only to authorized ser-
vice centres. Always require original
UNOX
spare parts.
Failure to observe the above suggestions can com-
promise safety of the appliance and the guarantee
will not be recognized anymore.
4
3
ENGLISH
LineMicro™
