Universal Laser Systems ULTRA X6000, User Manual

Page: 56 / 83

56
E
Power Setting
Displays the power percentage to be used for each laser. A power setting
may be set for each installed laser source.
F
Speed Setting
Displays the percentage of process speed applied to all colors in the
process.
G
Gas Assist Type
Enables selection of the type of Gas Assist to be applied. Options include
Gas , Air, and None. If using Coaxial Gas Assist , or the optional Lateral Gas
Assist , either the Gas or Air option must be selected.
If Gas or Air has been selected for any process, the user must select either
Gas or Air for all processes. If no Gas Assist is desired, the Coaxial or Lateral
Gas Assist attachment must be removed, and no process can be set to use
either Gas or Air.
H
Gas Assist Flow
Rate
Enables the target flow rate adjustment for the Gas Assist source. This
option is not available when None is selected for Gas Assist.
I
Pulses Per Inch
Displays the number of laser pulses per inch for the selected process.
J
Kerf Width
Enables Kerf Compensation, which allows users to compensate for the width
of a cut or mark when the value is set to any non-zero value.
Note that
Kerf Compensation will only be applied to shapes in the design
file that are completely closed. Shapes that are open, by even a small
amount, will not have the kerf compensation applied.
K
Repeat Count
The number of times to repeat the selected process.
L
Autofocus Toggle
Button
Enables or disables use of the Autofocus procedure before the selected
process begins. If a single material height is used, it is often more efficient
to enable Autofocus for the first process only, leaving subsequent processes
disabled.
M
Pierce Toggle
Button
Enables piercing at the beginning of each graphical element. Pierce Settings
may be adjusted in the Advanced Section of the System Configuration Page .
N
Save / Delete /
Discard Changes
Buttons
Select one of these options to: Save the process settings, Delete the current
process and move the assigned colors to the unassigned category, or
Discard any changes and return to the System Operations Page .