Universal Laser Systems ULTRA X6000, User Manual

Page: 26 / 83

26
FCC Compliance Statement and Warnings
This ULS laser system has been tested and found to comply with the Federal Communication
Commission (FCC) directives regarding Electromagnetic Compatibility (EMC). In accordance with
these directives, ULS is required to provide the following information to its customers:
This device complies with FCC Rules Part 15. Operation is subject to the following two conditions:
1. This device may cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and is found to comply within the limits for a Class A digital device as set
forth in Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the manufacturer’s instructions, may cause harmful interference to radio communications. Operation of
this equipment in a residential area is likely to cause harmful interference, in which case the user will be
required to correct the interference at his or her own expense.
Users should be aware that changes or modifications to this equipment not
expressly approved by the manufacturer may void the user’s authority to
operate the equipment.
This equipment has been type-tested and is found to comply within the limitations for a Computing
Device per FCC part 15, using shielded cables. Shielded cables must be used to comply with FCC
regulations.
CDRH Compliance
This device is specifically designed to comply with CDRH performance requirements under 21 CFR
1040.10 and 1040.11, and with European laser safety regulations under EN60825-1. CDRH is the Center
for the Devices of Radiological Health division of the Food and Drug Administration (FDA) in the USA. No
guarantees of suitability or safety are provided for any uses other than those specified by Universal Laser
Systems, Inc.
Recycling
By placing this symbol on our products and accessories, Universal Laser Systems
indicates that we are committed to helping reduce the amount of waste electronics
ending up in municipal landfills. Therefore, we urge consumers to recycle this
product and its accessories. Universal Laser Systems is equipped to recycle any of
its electronic products and accessories and will assist our customers with their
recycling options.
To recycle a ULS product or accessory, please email the ULS Service Support Team
at: support@ulsinc.com , or call: USA +1 480 609-0297, the Austria office at: +43 1
402 22 50, or the Japan office at: +81 45 224-2270.