SECTION C, PAGE 7
SOLUTION
PERSONALIZATION
Enter the maximum
WELD HEAT% increase
that you want to allow from the
keypad and press
The display will show:
Push and the display will show:
Enter the maximum
WELD HEAT% decrease
that you want to allow from the
keypad and press
If your control does NOT have the letters QC
in the model number, skip to C7.
C4. EHR/FAULT RELAY ASSIGNMENT.
The control has a relay that can be
jumper selected
to be used in one of two
ways:
C4.1 EHR
– E
nd
O
f
H
old
OPERATION.
When the
J3 jumper
is in the
EHR
position, the relay will close at the
end of every weld
.
If the button is pushed, the
EHR
relay will
NOT
close.
EXCEPTION:
If an external
NO WELD
switch is connected to terminal
NW1
and
this switch is
OPEN,
the
EHR
relay will
still
close at the end of a sequence.
MODIFIED HEAT LIMITS
MAXIMUM “-CHANGE”=0%
Want to change? Push
the YES or NO button
MODIFIED HEAT LIMITS
MAXIMUM “-CHANGE”=0
after entering data
Press YES
YES
YES
YES
SKIP
NO
WELD
Summary of Contents for SOLUTIONi
