SECTION C, PAGE 9
SOLUTION
PERSONALIZATION
C5.1 KEYPAD & INITIATE:
If you push every time one of the
three faults is detected, the
electrodes will stay closed.
To release and reset the fault do
one
of the following even if the
KEYPAD
is
CLOSED
:
1. Release and then close the
FOOT SWITCH
or
HAND SWITCHES
.
2.
Push any button on the keypad.
C5.2 KEYPAD & KEYLOCK:
This mode is useful for critical parts welding
when you want to require a supervisor to reset a fault.
If you push every time one of the three faults is detected, the
electrodes will stay closed.
To release and reset the fault do one of the following:
1. If the
KEYLOCK
is in the
OPEN
position, press
2. If the
KEYLOCK
is in the
LOCK
position, turn the
KEYLOCK
to
OPEN
and
then press
C6 FAULT RELAY MODE:
The
FAULT RELAY
can be
used in two
modes:
1.
CLOSE FOR REJECTED WELD.
In this mode, the relay will close after a
weld with any of the faults in
C4.
2.
CLOSE FOR ACCEPTED WELD.
In this mode, the relay will close after a
weld has been completed with
NONE
of the faults in
C4.
To select the desired mode, push:
2
YES
YES
PROGRAM
9
8
5
1
+
STEP
ENTER
Summary of Contents for SOLUTIONi
