FIRST TIME CONTROL SETUP
SECTION B, PAGE 12
B9.2 ROCKER ARM WELDER SETUP:
If you told the
SOLUTION
i
that your welder was a
ROCKER ARM WELDER,
the display will show:
Enter
DIMENSION A
in the photo to the right. This is the
dimension from the center of the pivot pin that connects
the air cylinder rod to the back of the rocker arm to the
center of the rocker arm pin.
Press
and the display will show:
Enter
DIMENSION B
in the photo
.
This is the dimension from the center of the
rocker arm pin to the centerline of the electrode holder.
Press
and the display will show:
Where the
SOLUTION
i
calculated
:
##.# =
AREA of CYLINDER X (A/B).
TYPICAL
TRANSGUNS
WITH
WELDING TRANSFORMER
INTEGRAL TO THE WELDER.
TYPICAL
ROCKER ARM
WELDER
B
A
YES
YES
CYLINDER to PIVOT
Distance 00.0in
After entering data
press YES
Distance from PIVOT
to ELECTRODE = 00.0
After entering data
press YES
TIP FORCE is
##.# times air psi
Be sure that the number matches including
the decimal.
Summary of Contents for SOLUTIONi
