![background image](http://html1.mh-extra.com/html/unipro/6002/6002_quick-manual_3891109011.webp)
Weld the bush on
12-15 cm from the piston.
The bush is mounted on the
pipe. The distance should be 12-
the exhaust pipe
exhaust
15 cm
from the backside of the piston. Do not
drill a hole in the exhaust pipe before
he pipe.
After the bush is welded on the
exhaust pipe, drill a 4.1 mm hole in the
middle of the bush through the exhaust
pipe. Be careful not to damage the pipe
on the other side when you drill
pushed all the way in and tightened.
Fix the cable to the seat, and all the
T
n
T
f
ater sensor
This is the sensor for measuring the water heat. Use either TEMP 1 or TEMP 2 for the water
u drive a kart with water cooled engine, the heat of the cooling water is of course
The water sensor is mounted on the hose that goes from
the cooler to the engine. It is best to mount the sensor
on the hose so the sensor sits near the seat, pointing
downwards.
Cut the hose in the right place and remember to put the
two hose clamps on the two ends of the hose before
inserting the T-junction in the hose.
you have welded the bush on t
through the pipe.
Mount the sensor in the bush.
After the hole is drilled, the sensor is
way to the Main Box, so it is well
protected.
he cable is mounted in the connector
amed TEMP 3 on the Main Box.
ighten the connector hard with your
ingers.
W
sensor. When yo
important for the performance of the engine.
Mounting the water sensor.
UNIPRO – The original Laptimer
11