Temperature sensors
The Unipro Laptimer can work with up to three temperature sensors. You can choose between the
following sensors:
•
Cylinder head temperature
•
Exhaust gas temperature
•
Water temperature (on water cooled engines)
•
Tire temperature sensor will be available in the near future
Besides the three temperature sensors the Unipro Laptimer ha
ilt in thermometer measuring
the environment temperature. This temperature is stored with the lap times and other data. This
can be a good help when analysing your results.
The temperature sensors can give you important information about the performance of you
engine, enabling to see the effect on both engine performance and lap times.
SETUP THE TEMPERATURE INPUTS
s a bu
When you have installed temperature sensors you need to setup the Laptimer. Turn on the
Laptimer and press SETUP until you see the temperature input screen.
This is the temperat
reen. It is here you
define how many temperature inputs you are using. Choose
the right combination of the 3 temperature inputs. The
reason to turn the inputs on or off is to save battery power
and to adjust the user interface to the rea
Use the
ure input sc
l setup.
and
buttons to select the combination of
temperature inputs you are currently using. You will only
have to do this again if you add or remove temperature sensors.
TEMPERATURE WARNING POINTS
This is the temperature warning point screen. Here you
can define a warning point for each active temperature
sensor. The picture shows the setting of temperature point 1.
Use the
and
buttons to adjust the temperature
point. Temperatures are shown in either d egrees centigrade
or Fahrenheit. If you has activated more than one
temperature sensor, you will go to the next warning point by
pressing
.
Temperature point 1 is the left g
nt 2
D and
temperature point 3 is the middle yellow LED. They start to blink when the temperature
rises above the warning point set.
reen LED, temperature poi
is the right red LE
UNIPRO – The original Laptimer
24
