Magnet count
Set the total number of magnets on the track.
When you press
from the stripe setup screen, you can
al number of magnets on the track. You can
etween 1 and 8 magnets. If you don’t know the
timer to use only
one magnet and then drive one lap. Then you can see how
edit the tot
choose b
number of magnets, you can set the Lap
many times the Laptimer triggers.
Use the
and
buttons to adjust the total number of magnets.
n
When the correct number of mag ets is entered, press
to edit the number of magnets
the next screen).
from the pit to the finish line (See
Magnet delay
ish
line.
This is the number of magnets you need to delay when going
s example, you need to
Set the number of magnets from the pit to the fin
from the Pit to the finish line. In thi
pass two magnets when going out from the Pit. This means,
that on the out lap (or first lap) the Laptimer ignores the first
two magnets and then start the Laptimer when passing the
third one.
Use the
and
buttons to
agnets delay.
adjust the m
Press
to save and return to the stripe setup screen.
More settings
If you want to get the full benefit of your Laptimer, we recommend that you use some of the more
advanced features and accessories. The most used accessories are:
•
Temperature sensors for cylinder head, exhaust and / or water
•
Speed kit, which enables you to use split times and speed
•
Data Analyser and PC Analyser to view and analyse your data
We will get back to this later in the Quick Guide, and you can read all about it in the Reference
Manual. With the settings mentioned above, you can start to use your Laptimer, getting precise
lap times and RPM values.
UNIPRO – The original Laptimer
17
