12
Instructions for the installer
3
INSTRUCTIONS FOR THE INSTALLER
WARNING!
This boiler has to be destined for the use
for which it has been expressively designed
for. Any other use shall be considered im-
proper and therefore dangerous.
This boiler is designed to heat water at a tem-
perature inferior to boiling point at an atmo-
spheric pressure.
WARNING!
These appliances are exclusively designed
to be installed inside adequate sitings.
Therefore these appliances must not be in-
stalled and operated outdoors. An outdoor
installation could cause malfunctioning and
could be dangerous. For external installa-
tions, it is recommended to use appliances
which are specifically designed and predi-
sposed for this purpose.
Before installing the boiler the following points
have to be carried out by a competent engine-
er:
a) The whole system should be thoroughly flu-
shed in order to remove any residual dirt or
grime which could compromise correct boi-
ler operation.
b) Check that the boiler has been preset for
operating with the gas type available.
This is verifiable via the indication on the
packaging and on the data badge;
c) Check that the chimney/flue pipe has an
adequate draught, does not have any con-
strictions, and that no other appliance’s flue
outlets have been fitted, unless the chim-
ney is serving more than one heating ap-
pliance, according to the specific standards
and regulations in force. The connection
between the boiler and chimney/flue outlet
can be made only after this verification has
been carried out.
WARNING!
In rooms where aggressive vapours or dust
is present the appliance must operate inde-
pendently from the air present in the boiler’s
location room!
WARNING!
The appliance must be installed by a quali-
fied engineer, who complies to the techni-
cal-professional requirements according to
the law 46/90 and whom, under his own re-
sponsibility, guarantees the compliance of
the standards according to the latest regu-
lations.
WARNING!
The appliance must be installed only on a
vertical flat wall, made of non combustible
material.
The appliance must be positioned so that at
least the minimum operational and servicing
clearances are provided.
NOTE:
The boiler must be connected to a heating sy-
stem which is compatible to its performance and
output.
3.1 - GENERAL WARNINGS
Summary of Contents for Alkon Cargo 35
Page 1: ...ALKON CARGO 35 INSTALLATION AND SERVICING MANUAL 00332603 2nd edition 04 2008 ...
Page 46: ...NOTE ...
Page 47: ...NOTE ...
