Additional Technical Remarks
Contact
Impedances,
Voltages
it be necessary to extend
Stereo Lead K 541,
Output
impedance of the input source, the input impedance of the playback
machine
well
the
capacity must be taken into consideration
in order to avoid
of response in the high frequency ränge during
both record and playback.
1. MICRO Socket
Input Signals at pins 3/2 and 5/2 (2 = ground)
be between
mV
and 70 mV. In addition to all
dynamic
UHER Electret Condenser
M 645 may also be connected
to this socket. The power supply for the condenser microphone is pro-
vided by the microphone's
battery (see the instructions for use
supplied with the microphone).
2. Headphones Socket
Output Signal delivered to the two pins 4/2 and 5/3
and 3
= ground) is 4 V at each; Output impedance is approximately 200 ohms
at each.
3.
l Socket
Input Signals at pins 1/2 and 4/2 (2 = ground) may be between 1.5 mV
and
mV. Input impedance is 15
at each. For input Signals
of
than 70 mV, it is advisable to feed the Signals to pins 3/2 and
5/2 (2 = ground) of the Radio/Phono l input, using a crossover
Input Signals at these pins may be between 40 mV and 2.8 V; input
impedance is
megohms at each. For input Signals of more than 1.5 V,
it is advisable to use the Phono II input socket
.
In playback, Output Signals delivered to pins 3/2 and 5/2 (2 = ground)
of the Radio/Phono l socket are approximately 600 mV at each, out-
put impedance being
kohms at each.
4. Phono II Socket
Input Signals at pins 3/2 and 5/2 of this socket may be between 200 mV
and
Input impedance is 50 kohms at each.
5. Remote Control Socket A
Via pins 4 and 3 (3 = ground), the SG 561 may be switched to PAUSE
with either UHER Manual Remote Control Switch F
or Foot-Oper-
ated Remote Control Switch F
An output voltage of 26 V (output impedance 390 ohms) is delivered
to pin 1 for Operation of UHER
The
Signal of the
channel is run to pin 2, that of the right channel to pin 5.
6.
Projector Socket
The monitor Output of the left channel is at pin 1 of this socket, that
of the right channel at pin 5 (output voltage approximately 600
Output impedance approximately 15 kohms at each). The "Dia-Pilot"
head is run out to pins 4 and 6 (6 = ground) for recording control
pulses in film dubbing. Slide changing for the
projector is triggered
via pins 2 and 3.
43
Summary of Contents for sg 561 royal
Page 1: ...UHER SG561 ROYAL Betriebsanleitung Operating Instructions Instructions d emploi ...
Page 70: ...K 853 A 124 l T r A261 A 403 G J I L 1 1 3 Akustomat F411 F211 F411 W 214 ...
Page 72: ......
Page 74: ...0 91 10 So Mo Do 8 UHER WERKE MÜNCHEN 366 47019 DEF II 015 1078 R Printed in German ...
