uher sg 561 royal, Operating Instructions Manual

Page: 37 / 74

6. Playback Operation
6.1 For Users a
Playback may be directly amplifier stage.
listening through the of the SG 561
may be switched in or out of circuit, desired (see sec. 2.2). When
external loudspeakers are connected, the built-in Speakers may also
be switched in or out of circuit
desired (see secs. 2.5 and 2.6).
Playback Procedure:
1. Load tape described in sec. 1.7 and turn Tape Speed
tor ® to the speed of the recording.
2. Set Mode Selector ® to of recording (see sec. point
3. Set Tape Transport Switch ® in START position.
4. For playback through the power stage of the SG 561, adjust the
volume of the two channels to desired by means of Controls ®
and ® ; then adjust treble Control ® and bass response
Control © . When playback is to be through the Speakers of an
audio System, all of these adjustments should be with the
amplifier controls of the System itself.
5. After playing one run ot the tape, exchange the on the
right spindle with the empty one on the the tape once
more and continue playback described above.
6.2 Audio Enthusiasts
Playback quality depends chiefly the quality of the recording.
Neither the world's best amplifier nor the world's best loudspeakers can
correct wrong record level settings. In Stereo Operation, at the
built-in loudspeakers serve monitoring purposes; yet considerably
better monitoring of a stereo recording is possible Stereo head-
phones are used. weak playback of high frequencies suggests that
the tape head should be cleaned (see sec.
In stationary Operation, playback will be through loudspeakers connect-
ed either to the (per channel) power stage of the SG 561 or
to the amplifier of a hi-fi audio System. In case of the latter, give careful
attention to the remarks made in sec. 4 the SG 561 to
the Amplifier of a Hi-Fi Sound System". All Steps for setting up
the SG 561 for playback should be accomplished in the Order des-
cribed in sec. 6.1 above.
35