UFESA FR1000, Operating Instructions Manual

Page: 8 / 46

IMPORTANT NOTES
• Read through these instructions carefully
before using the appliance for the first
time. Safeguard them for future reference.
• Before plugging it in, check that the
voltage corresponds with that stated on
the characteristics plate. Use an electrical
socket with an earth connection.
• Never immerse the appliance in water
or any other liquid.
• Make sure that all of the pieces are
completely dry and that there are no tra-
ces of water in the pan before using the
appliance.
• Never switch the appliance on before it
has been filled with oil or fat. The oil or
fat level must always lie between the
minimum and maximum marks.
Before beginning a new frying or fondue
session, make sure that there is sufficient
oil, fat or sauce in the fryer.
• In fryer mode, only use oils and fats
recommended for fryers. When using fresh
fat/lard in blocks or pieces melt it down
in a saucepan beforehand and then pour
it into the fryer before switching it on.
• Do not overfill the basket as this may
cause the hot oil or fat to spill over the
top of the fryer.
• Keep the appliance out of children’s
reach. Never leave it unattended.
• Avoid moving the fryer while it is
operating.
• Do not touch the hot surfaces. Use the
handles and controls.
• Do not obstruct the ventilation grille on
the top lid.
• After use, set the control knob to the
OFF position, unplug it from the mains
supply and leave it until it has cooled
down sufficiently before moving it.
If the oil or sauce has to be emptied out
then leave it until it is completely cold.
ENGLISH ENGLISH
ENGLISH ENGLISH
ENGLISH
• Always unplug it from the mains supply
when it is not in use and before cleaning
it.
• Do not unplug it by tugging on the mains
cable. Never leave the mains cable
hanging freely.
• Keep the appliance and the cable away
from hot surfaces.
• Do not use the appliance for uses other
than those stated in this manual.
• To avoid risks, do not use the appliance
if either the cable or plug are damaged.
Cable repairs and replacements must be
carried out exclusively by an Authorised
Technical Service Centre.
• This appliance has been designed for
domestic use only.
USE
This appliance is specially designed for
use as a fryer and fondue pot.
FRYER MODE
Wash the basket, pan and lid in hot soapy
water and then rinse and dry them before
using the appliance for the first time.
1. Place the fryer on a flat, stable surface
and pull the cable fully out of the cable
compartment making sure that it is not
touching any nearby heat sources.
2. Open the lid and take out the basket.
3. Fill the pan with oil without going
beyond the maximum mark (0.5 litres).
The oil or fat level should always be kept
somewhere between the minimum and
maximum marks.
4. Turn the temperature control to the OFF
position and plug the appliance into the
mains supply.
The ON/OFF control light will come on
(red pilot lamp).
max min
Oil 0,5L 0,45L
Fat 0,4K 0,37K