Rev: 2015.06.28.v01c
page 27
Thread the clevises on far enough so
that there is only about 3/16” of thread
showing. This will give a little
adjustment in either direction if needed
later.
With the servo centered and the
elevator in the neutral position,
measure from hole to hole.
With the dimension just taken, remove
enough of the control rod so that you
can match that dimension hole to hole
with the clevis-control rod assembly.
Attach the clevis with med. CA.
Round up your motor, the hardware it
came with and the ESC that will be
used.
Repeat the process for the rudder.
Install the control rod on to the servo
and elevator control horns. With the
servo electronically centered, adjust the
threaded end if needed to get the
elevator perfectly neutral
