Rev: 2015.06.28.v01c
page 13
Locate the servos that will be used for
the LEF’s. Depending on the size servo,
you may or may not need to adjust the
size of the cut out.
Figure out where the slits need to go for
the ears of the servo, and adjust the
size of the pocket if necessary. Make
sure that the output arm of the servo
lines up with the horn of the LEF
Repeat for the other side. Some servos
may stick up a little from the surface of
the wing, this is ne.
Press the servo into position.
Locate the slits for the servo tabs by
lining up the output shaft/horn with
the center of the slot in the wing as
shown above.
Locate the servos that will be used for
the ailerons. As with the LEF’s, the size
of servo being used will determine if
there needs to be any trimming of the
pre-cut pocket.
