Rev: 2015.06.28.v01c
page 24
Once happy with the t-up, remove the
spar, squeeze some Welders into the
slot and slide the rod back in. Wipe
away any extra glue. Set a side to dry
for a bit.
Next up is the tail servos. There are two
different servo trays included with the
kit. Pick the one that best ts your
servos.
This build uses the Twisted Hobbys’
power combo, so the ICE Servo Tray is
a prefect t for the servos in the that
combo.
Using the Wet Welders Method, mount
the servo tray to the provided notches.
Once attached everything should be
ush.
From the UNDERSIDE apply a bead of
low temp hot around the area were the
servo and wood meet. Using hot glue
will make it easier to sh the servos out
in the future if necessary.
Make sure the servos are electronically
centered, the horns are facing as
shown, and that the servo bodies are
ush with the servo tray.
