Rev: 2015.06.28.v01c
page 15
Duplicate the dimension in the holes
spacing of the clevises. Use medium CA
to secure the rod to the clevis. Do one
end rst than measure again. Make
sure the orientation is correct.
Attach the control rod between the
servo and the LEF. If it is slightly off
center, this can be adjusted with sub-
trim later when setting up the radio
program.
Repeat for the other side.
With the control surface and servo both
in neutral positions, measure from hole
to hole like was done with the LEF.
Put a skim coat of Welders on the base
of the horn, and squeeze some into the
slot with the nozzle of the tube. Install
the horn while the glue is wet and
position the horn as needed.
Next cut a slot in the wing for the
aileron control horn. Use a square to
get the slot in line with the servo arm.
Cut the slot so that the clevis hole in
the horn will be on the hinge line.
