Rev: 2015.06.28.v01c
page 11
The wood pieces will install into the
pre-cut slots pictured above. Welders
should be used for this.
Apply a Wet coat of Welders to both
sides of the part AND squeeze a little
into the slot area. If possible keep the
“notch” free of glue. Then slide the
wood piece in, arrow pointing forward.
Slide the wood piece in until it is ush
and wipe away any excess glue that
squeezed out
Once the whole length of the spar is
install, it should look similar to the
above picture.
Install the spar DRY. Make sure that
the slit you cut was “just” deep enough
so that the spar when fully seated will
be ush with the wings surface.
Next, cut a 3mm deep slit, centered and
long enough to accommodate the
carbon spar. Location front to back is
determined by the relief cut in the small
wood pieces just installed
