Rev: 2015.06.28.v01c
page 8
While the control surface are relaxing,
gather up all your radio gear.
IT IS IMPERATIVE TO DO THE
NEXT COUPLE STEPS PRIOR TO
INSTALLATION!
Attach connector to the ESC that
matches the batteries you will use.
Note - if using the recommended
battery and ESC location you will need
to make an extension. See page 37.
Plug everything in, bind the radio per
mfg instructions and check that all the
servos operate correctly and smoothly.
Hang on to the motor near the wires,
and test it’s operation as well.
Using the “tack up” method apply a
skim coat to the mating surfaces.
Note - you have to build a Left and
Right had version. Take this into
account when applying the glue.
Locate the above items needed for the
Lead Edge Flap (LEF) assemblies.
Screws shown are the 4 tiny M2x5
screws that are located in the hardware
bag.
With many ESC’s it is required to
program throttle end points. Follow the
mfg instructions for this operation and
complete the process at this time.
