Rev: 2015.06.28.v01c
page 35
Split the Two SFGs as shown above.
CA or Welders can be used to attach
these pieces.
Take the piece shaped like above (there
should be two of these) and install it
into the slots from the leading edge that
are closest to the aileron servo.
The one that was just split, installs
onto the aileron control surface, just
behind the SFG that was just installed.
Elevator SFG is pictured above, it
installs on the inside of the counter
balance part of the elevator.
Take the other part shaped like the one
just installed and put it in the slots
closest to the wing tip.
Next take the one shaped like pictured
above (there should be 4 of these) and
install in the position one set of slots in
from the wing tip.
