Rev: 2015.06.28.v01c
page 33
Wheel axles and mounting system is
next. Welders or CA can be used, CA is
the recommend process. You will also
need some sewing thread. Kevlar or
other stuff can be used but not needed.
Insert the small white axle holder
between the protruding landing gear
spars and secure with thin CA.
With a pair of ush cutter, remove the
extra length of the landing gear spars.
Repeat for the other side.
Slide one of the small wood nut shaped
parts onto the stub axle as far as it will
go, make sure it is square to the axle,
then secure with a couple drops of
medium CA from the back side.
From the front view, the stub axles
should be parallel to the ground. Note
that the stub axles stick thru about
3/16” or so, apply a small drop of CA to
hold it’s position.
Install the stub axles thru the oval
shaped holes of the axle holders. from
the top view make sure they are parallel
to each other and perpendicular to the
direction of ight.
