FIG. 61
Next, attach a Snap Link (#90) to the
Lat Cable (#31)
, in the po-
sition as shown above, and secure it into place using one Shoulder Bolt
3/8 X 3/4 (#86), and one Nylon Insert Lock Nut 5/16-18 (#99). Use the
supplied Hex Key 3/16” (#92) and a 1/2” combination wrench to fasten this
assembly properly.
Note:
Refer to Fig A on page 19 for further illustration of this as-
sembly.
Connect the
Lat Bar (#35)
to the
Lat Cable (#31)
using the Snap Link
(#90). Rest the
Lat Bar (#35)
onto the
Lat Bar Holder (#30)
when not in
use.
17
BRT-1 “The Brute” Plate Loaded Home Gym
FIG. 60
Insert a Rubber Grip 1 x 6 1/4 (#51) over each one of the tube-
ends of the Low Row Bar 20” (#36), and the Lat Bar 48” (#35), as shown
above.
Note:
To facilitate the insertion of these Rubber Grips, use Windex
or household glass cleaner.
NOTE:
FIG. 62
Locate the Coil Chain 3/16 X 21 (#91), two Snap Links (#90)
and attach them to the
Low Row Bar (#36)
and the
Leg Extension Cable
(#32)
, as shown above.
Rest the
Low Row Bar (#36)
onto the notch located on
Triangular Rein-
forcement Plates
when not in use.
FIG. 63
Insert a Ring-Grip Self-Locking Pin (#98) into the bottom hole of
the two
Stabilizers (#4)
, as shown above. Use these Ring-Grip Self-
Locking Pins (#98) at all times to prevent the
Press Arms (#8, #9)
from
falling beyond this point in case of accidental releasing of the Turn/Pull
Pins (#42)
NOTE:
