FIG. 12
Caution:
It is strongly recommended to use another per-
son in assisting with this assembly.
Insert the
Main Frame (#5)
between the two
Triangular Reinforcement
Plates (#2, #113)
, in the position as shown above. Next, secure the
Main
Frame (#5)
to the
Triangular Reinforcement Plates (#2, #113)
using
three Hex Head Cap Screws 1/2-13 X 3 1/4 (#69), six Flat Washers SAE
1/2” (#68), and three Nylon Insert Lock Nuts 1/2-13 (#74).
FIG. 13
Insert a Nylon Pulley 4 1/2 Rd. (#64-Labeled E) into the pulley
bracket located on the
Main Frame (#5)
and secure it into place using one
Hex Head Cap Screw 3/8-16 X 3 (#81), two Flat Washers SAE 3/8” (#84),
and one Nylon Insert Lock Nut 3/8-16 (#83).
Note:
The black boxed letter pointing to the pulleys are used
throughout this manual as reference to the Cable Mapping Dia-
gram on page 20. These black boxed letters will be primarily used
for locating certain pulleys during the cable routing process begin-
ning with
Fig. 13.
5
BRT-1 “The Brute” Plate Loaded Home Gym
CAUTION
NOTE:
FIG. 14
Confine the
Arm Holders (#6)
within the
Stabilizer’s (#4)
tubes
using two Hex Head Cap Screws 3/8-16 X 2 1/2 (#79), and two Nylon In-
sert Jam Lock Nuts 3/8-16 (#85).
FIG. 15
Rest the
Right Press Arm (#9)
on the corresponding
Arm
Holder (#6)
and affix it to the
Main Frame (#5)
using one Hex Head Cap
Screw 1/2-13 X 5 1/2 (#73), two Flat Washers SAE 1/2” (#68), and one
Nylon Insert Jam Lock Nut 1/2-13 (#75). Repeat the same procedure for
the
Left Press Arm (#8)
.
