TS Industrie Super Premium 30ER, Technical Manual

Page: 18 / 76

Super Premium 30ER / 35DR / 35DRI
18
23/01/2014
C . The shredding unit
It is made up of a feed hopper ( 1 ) a feed roller ( 2 ) with serrated bars and a rotor that shreds
the matter.
1) Feed cylinder
It leads the matter at constant speed toward the shredding rotor. An anti-jamming
system stops the latter when the rotor’s speed descends too low (jamming at
shredding level), it automatically starts rotating again when the rotor picks up
sufficient speed to shred correctly.
It can be activated in both rotation directions (forward and reverse run) with the
pushers command
(
3
) .
Its rotation speed is adjustable with the knob (
4
) located on the distributor
2) Shredding rotor:
Key element of the machine, it shreds the matter brought by
the feed roller.
It is put in rotation by progressively activating the clutch
The feeder’s
hydraulic drive is activated by a handrail
(
1
) located under the rear end of the feed hopper.
D. The shaft.
Allows the evacuation of chips. Its upper part swivels over + 180°. Its cap is adjustable in
vertical inclination.
G E N E R A L D E S C R I P T I O N
A N D O P E R AT I O N