TS Industrie Super Premium 30ER, Technical Manual

Page: 32 / 76

Super Premium 30ER / 35DR / 35DRI
32
23/01/2014
-Tighten the screws category 12.9 to 16 M.kg torque (157
Nm),
and make sure the blades and inserts lean against the
wall.
-Close the chute and the covers.
-Start the engine and warm it during a few minutes.
-Accelerate to maximum speed to make sure no abnormal
vibrations disturb the functioning of the machine.
-Install identical or newly ground blades.
IMPORTANT: the blades must be ground by a professional using specific tools, and not
with a grinding disc. Make sure tha 35° angle of the cutting edge is respected. The minimal
lengt of
A should not be smaller than 50 mm after grinding. (The length of a new blade is
60 mm).
M A I N T E N A N C E
DISASSEMBLY TO REPLACE THE BLADES AND THE HAMMER
INSERTS
Remove the ignition key before proceeding.
-The hollow hexagonal screws of the blades and hammer inserts are mounted at the
manufacture
without Loctite at a torque of 16 M. Kg (157 N.m). Use the appropriate
wrench that is in good condition to remove them.
-Open the chute as described on previous page.
-Remove the screws from blades and inserts. (For the assembly later on, only use the news
screws
category 12.9 ).
-Clean the contact surfaces of the blades and the inserts clean at the base (1) as well as the
wall (2) .
A torque tightening of the screws is essential to prevent their
accidental release.