![background image](http://html.mh-extra.com/html/troy-bilt/flurry-1400/flurry-1400_professional-shop-manual_1173270042.webp)
Snow Flurry 1400
38
Auger housing
To remove/replace the auger housing:
1.
Disconnect the power supply of the snow thrower.
2.
Remove the auger by following the procedures
described in the auger section of the chapter.
3.
Remove the motor cover by following the proce-
dures described in the upper synchronous belt sec-
tion of Chapter 3: Belts and Pulleys.
4.
Remove the lower discharge chute by following the
procedures described in the lower discharge chute
section of this chapter.
5.
Remove the shave plate by following the proce-
dures described in the shave plate section of this
chapter.
6.
Remove the two carriage bolts and nuts that hold
the lower handle bar to the bottom of the auger
housing using a 10mm wrench. See Figure 4.25.
7.
Remove the two screws that hold the left side panel
to the auger housing using a #2 phillips screw
driver. See Figure 4.26.
8.
Slide the auger housing out of the snow thrower.
9.
Install the auger housing by following the previous
steps in reverse order.
NOTE:
When installing the auger housing, make
sure the lower motor housing and the foam
gasket are in the slots in the auger housing.
See Figure 4.27.
10.
Test run the snow thrower in a safe area before
returning it to service.
Figure 4.25
Carriage bolts
Figure 4.26
Screws
Figure 4.27
Lower motor housing
Foam gasket
For Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
Summary of Contents for Flurry 1400
