Belts and Pulleys
25
5.
Remove the screw from the rear of the motor cover
using a #2 phillips screw driver. See Figure 3.6.
6.
Remove the motor cover from the right side of the
machine.
7.
Loosen the nut and bolt that the reduction pulley
rotates on using a 12mm wrench and a 13mm
wrench.
8.
Slide the belt off of the pulleys.
To install the upper belt:
9.
Slide the belt over the reduction and the motor pul-
leys.
10.
Using a large flat head screw driver, gently pry on the
head of the reduction pulley bolt to apply tension to
the belt.
11.
While holding tension on the belt, tighten the reduc-
tion pulley nut using a 13mm wrench.
NOTE:
The prying force applied to the bolt head will pre-
vent the bolt from turning while tightening the nut.
12.
Install the lower belt and the covers by following 1 - 5
in reverse order.
13.
Test run the snow thrower before returning it to ser-
vice.
Figure 3.6
Screw
Figure 3.7
Reduction pulley bolt
Motor
For Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
Summary of Contents for Flurry 1400
