Snow Flurry 1400
30
To remove/replace the lower discharge chute:
1.
Disconnect the power supply of the snow thrower.
2.
Remove the four screws that hold the front cover to
the auger housing using a #3 phillips screw driver.
See Figure 4.3.
NOTE:
The lower discharge chute has a spring
loaded detent ratchet pressing against it. As
the chute is pulled away from the auger
housing, this ratchet will fall out. See Figure
4.4.
3.
If replacing the lower discharge chute, remove the
upper discharge chute from the lower chute.
4.
Tip the snow thrower back so that the chute opening
is facing up.
5.
If necessary, insert the springs into the detent
ratchet.
6.
Apply a light coat of lithium grease to the teeth sec-
tion of the detent ratchet.
7.
Install the detent ratchet and spring in the auger
housing so that the spring slide over the bosses in
the housing. See Figure 4.5.
8.
Insert the lower discharge chute into the auger
housing.
9.
Install the front cover.
10.
Test run the snow thrower before returning it to ser-
vice.
Upper discharge chute
Figure 4.3
Front cover
Figure 4.4
Detent ratchet
Figure 4.5
Bosses
Detent ratchet and springs
For Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
Summary of Contents for Flurry 1400
