TrojanLabel T3-OPX, User Manual

Page: 57 / 78

T3-OPX installation Page | 56
7.1.1 Initialize height control
Press the button for the unit to initialize the height controllers. When the unit is powered on will the initial
Media Path State status be ”Uncalibrated” and the unit can not move up or down.
When pressing the button will the height controllers move to the top position and the Media path state will
change to ”Ready”.
7.1.2 Print unit height
Use the -/+ buttons to move the unit up or down on increments of 0.2 mm.
Enter a value and the unit will move to the position.
7.1.3 MailTable (MT1/2) controls
7.1.3.1 Conveyor speed (MT1 and MT2 controls)
Move the table belts forward or backward , each push will increase the speed by 1 ips (please
note that there will be some latency, so rapidly consecutive presses, will not be registered). Press stop
to move the belts to a halt.
7.1.3.2 Fan control (MT1 and MT2 controls)
Use the start button to test the fans, use the stop button to stop the fans.
Use the Zone (1-5) controls to individually set the fan speed from 0 to 100.
7.1.3.3 Emergency stop
The emergency stop placement:
Print height controls
MailTable controls