Trinnov Audio Altitude16, User Manual

Page: 95 / 156

User manual
95
6.11 _CHECKING THE SPEAKER POSITIONS AFTER CALIBRATION
The Optimizer Settings/Positions page displays the measured speaker locations in real-time during
calibration.
Three views are provided:
• Top view: The speakers are seen from above;
• Elevation view: The speakers are seen from the listening point. Relative degrees of elevation and azimuth are displayed;
• Details view: A table listing the measured distance, elevation, azimuth, level, delay etc…
By default, the Optimizer page always displays the reference speaker positions in green color. These positions are specified in the
template of the initial speaker layout (2.0, 5.1, 7.1 or one of the Atmos, Auro-3D, DTS or Trinnov layouts).
Figure 92: Top view of a layout after calibration
As the calibration is performed, the real position of each speaker is displayed after the 3rd MLS burst.
The
Top View helps to identify the wrong speaker placements. It might be necessary to reposition if the microphone is not
perfectly pointed towards the center of the front stage, but that would only impact the visual representation.
Figure 93: RT60 display
This view also provides the RT60 on the top left corner of the page.
• Overlay both representations with the Scale and Ref. Radius options to verify the compliance with the recommended placements.
• The channel name displayed on each speaker is related to the channel order defined in the Speakers/Room setup tool.
• The color of the loudspeakers depends on remapping settings.
• The Elevation View uses the same color codes to display the real speaker positions. It indicates whether the microphone
was or was not correctly leveled during the calibration: