Trinnov Audio Altitude16, User Manual

Page: 81 / 156

User manual
81
by manually adjusting levels, delays and polarities of each driver. The filters applied in the 3D view of the Wizard will be
used, but you can manually change them.
No calibration: jump directly to the next step without modifying the delay or the level of the crossovers (set at 0). The
filters applied in the 3D view of the Wizard will be used.
When you calibrate a crossover, you will probably have to increase the volume. Effectively, as the MLS signal is split to 2, 3
or 4 ways, it will lose in strength. The goal is to raise the level of the test signal far enough above the background
noise in the room that we can be certain of a high-quality measurement. Make sure to calibrate your setup with the
same volume for each speaker.
Once the procedure is chosen, click on Next.
Figure 71: Set the type of calibration for the crossover
6.7.2 _ACTIVE FILTERS AUTO CALIBRATION
The list of your multi-way speaker(s) is shown on the picture above.
Figure 72 Calibrate the multi-way speaker
The status indicate if the calibration has been done. Click on Calibrate to launch the calibration. All speakers will be
calibrate following the order of the list.
NOTE: This value is a reference that works most of the time but it’s not an obligation.