Transtech Transputer, User Manual

Page: 44 / 200

Board Configuration Jumpers
36
Transputer Motherboard User Manual TMB M 711
4.1 Board Configuration Jumpers
This section describes the various board configuration settings and
TMB03 specific functionality.
Most of the configuration options are adjusted by the means of a
jumper block at the top right corner of the board which is shown in
figure 31 for reference.
The jumpers are briefly described below, and in detail in the following
sections.
IBM/UP The source of control for the TRAM in slot0
can be from either the host PC or from the
edge connector (UP).
Mod0SS The TRAMs in slots 1, 2, 3 & 4 can be
controlled either from the subsystem of the
TRAM in slot 0 or from the source which
controls slot 0.
AS0/AS1 The board’s IO address can be set to #150,
#200 or #300.
10MB/s The transputer link speeds can be set to
10MHz or 20MHz.
M & S Allow the board to be used as a Master or
Slave board.
IBM/UP
Mod0SS
AS0
AS1
10MB/s
M S
Figure 31. Board configuration jumpers