Transtech Transputer, User Manual

Page: 162 / 200

Solaris 2 Installation
154
Transputer Motherboard User Manual TMB M 711
5. Select the installation directory. Use the Browse dialog if you wish
to change this from the default directory
c:\tps
. Click on the
Next button.
The selected software will be now be installed.
6. When the installation has successfully completed, a Setup
Message is displayed. Click on the OK button to exit from Setup.
7. Add the following lines to
autoexec.bat
for an ISA card at I/O
base address 150 hex:
set TPS=c:\tps
set PATH=%TPS%\bin;%TPS%
set ISEARCH=%TPS%\tp\4libs\ %ISEARCH%
set ICONDB=%TPS%\lib\dos.db
set TRANSPUTER=150
For a TMB17 PCI card, use:
set TRANSPUTER=tmb17
8. Now re-boot the machine.
11.2 Solaris 2 Installation
11.2.1 FORCE CPU-3CE
If you are using a FORCE SPARCE CPU-3CE card, please read this
section carefully when selecting a VME base address for each VME
Transputer board such as a TMB14 to be installed.
The FORCE SPARC CPU-3CE card maps a single window of the
VME address space into its processor memory map. All of the
addresses used for the installed VME cards must be within this
window. The PROM monitor variable
vme-a32map
should be set to
the top VME address bits of the window.
Also, part of the VME memory map is occupied by memory and
registers by the 3CE. You should avoid using base addresses for the
VME Transputer card which conflict with these.
For a single TMB14 to be controlled by a 3CE, a VME base address
of
0x0800
is often suitable.This can be achieved by setting the
TMB14’s VME base address switches to
0
and
8
. In this case the
value of
vme-a32map
should be set to 15:
ok setenv vme-a32map 15