Basic
Configuration via CLI
Trango Broadband Wireless — User Manual M2400S Rev A
Page
21
Section 5 Basic Configuration via CLI
This section covers how to utilize the radio’s CLI interface to establish a working wireless link.
In this section, the most common settings using the CLI are discussed. Topics include:
•
Access Point Basic Settings
•
Subscriber Unit Database Settings
•
Subscriber Unit Basic Settings
See Appendix A
−
Command Set Reference, for a complete listing of CLI commands.
See the “Getting Started” section for a description of how to access the radio using the telnet interface.
Access Point Basic Settings
After logging onto an AP or SU, it is good practice to type the
sysinfo
command to see the radio’s basic system
information. Example (Access Point):
#> sysinfo
[Hardware Version] 8006
[FPGA Version] 04042201 [Checksum] 47231EEE
[Firmware Version] AP 1p0x8H8006D04061502 [Checksum] F8815A5B
[Device ID] 00 01 DE 18 6A 05 [S/N] 01600005
[Base ID] 1234 [AP ID] 01
[System Up Time] 0 day(s) 01:37:29
[Opmode] on [Default Opmode] on
[IP] 10.8.1.232 [Subnet Mask] 255.255.255.192 [Gateway] 10.8.1.193
[Login Password] RW
[Httpd Port] 80 [Httpd Status] listen
[Telnetd Port] 23 [Telnetd Status] connected (10.8.0.60,1454)
[Tftpd] disabled
[RF Tx Power] 10 dBm
[RF Rx Threshold] -80 dBm
[MIR Threshold] 5 Mbps
[Ch#01] 2405 Mhz [Ch#02] 2415 Mhz [Ch#03] 2425 Mhz [Ch#04] 2435 Mhz
[Ch#05] 2445 Mhz [Ch#06] 2455 Mhz [Ch#07] 2465 Mhz [Ch#08] 2475 Mhz
[Default Channel] 1 e [Active Channel] 1 e
[Broadcast Packet] block [SU to SU] off [TCP/IP for SU] on
[Remarks]
[RF Rx] 0 kbps [RF Tx] 0 kbps [Eth Rx] 3 kbps [Eth Tx] 5 kbps
Many of these parameters can be changed by the user. A description of each of these changeable parameters, along
with the related command is shown in the table below.
!
Important!
When changing settings, it is usually necessary to type the
save ss
command in order to update
the radio’s flash memory. If you do not type the
save ss
command, the setting will be lost the next time the
radio is rebooted or power cycled.
.
AP SYSTEM INFORMATION PARAMETERS AND RELATED COMMANDS
AP Parameter
Description
Related CLI Command
Device ID
MAC Address of AP
N/A
Base ID
Specifies the cell or cluster to
which the AP belongs. Base ID
must match in AP and SU in
order to establish a wireless
link.
set baseid <baseid>
Example:
#>set baseid aa12
