ARTC-SVX005B-EN
13
Figure 4. Recommended chiller/heater module rigging
After setting each module, remove front or rear access
panels to improve access to components when making
connections.
Rigging, Lifting, and Moving the Chiller/
Heater
The PolyTherm Simultaneous Chiller/Heater is
delivered to the customer’s site as individual modules.
Limitations on the methods and materials that can be
used to rig, lift, or move a chiller/heater or an individual
module include:
•
Maintain the module in an upright position at all
times.
•
Rig, lift, and move by strapping and lifting by
overhead means.
•
Position lifting beams or spreader beams to prevent
lifting straps from rubbing or contacting module
side panels or electrical boxes. Attach rigging bar
on each end of module where 1 3/8 inch holes are
provided.
•
Use caution when lifting due to configuration of
components. Module could be heavier on one side
than the other.
•
Certain configurations of modules can be top-
heavy. Move modules slowly with consideration to
each module’s center-of-gravity.
•
Do not use cables, chains, or any other type of
metalized strapping to lift a module.
•
Do not push a chiller/heater module along the floor
using manual or mechanical means.
