54-0208-01
4.5
Completing the Installation
Step
Page #
Done?
If you routed the antenna cable through the roof, you used the
2.19
supplied fitting and backing plate and sealed the holes.
You recorded the new height of the vehicle and informed the user.
2.22
You did
not
disconnect the short cable pre-connected on the
3.3
receiver’s rear panel.
If you cut the antenna cable, you used an LRC/Augat T1000 tool
3.5
to attach the supplied F-connector to the end of the cable.
You connected the antenna cable to the receiver.
3.8
You connected the RF converter to the receiver and placed it
3.8
3 feet away from the receiver and other electronic devices.
You connected high-quality audio/video cables from the receiver to the
3.9
vehicle’s entertainment system.
You connected the receiver’s power cable to +12 VDC switched
3.12
(accessory) power and did not connect other devices to the same circuit.
You mounted the receiver in a dry location away from any heat sources
3.14
and allowed plenty of room for ventilation.
You installed two “AAA” batteries in the remote control.
4.3
Receiver Location: