7.
At each bracket, position a retaining block
underneath the crossbar and insert two swivel
nuts,
1
⁄
4
" flat washers, and lock nuts into the
captive holes from below. While holding this
hardware in place, screw the bracket’s screws
into the retaining block’s swivel nuts, washers,
and lock nuts using a
1
⁄
4
" driver and the supplied
T27 TORX bit. After securing all four brackets to
the crossbar, verify that all cushions are pressed
firmly against the crossbar, providing a solid
grip. Also check to make sure that all eight
screws have engaged the nylon inserts in the lock
nuts.
8.
Attach a protective cover onto each clamp. The
covers simply snap into place at the sides of the
brackets.
54-0208-01
Installing the Antenna
Securing the TORX Screws
Retaining Block
Attaching the Cover
Two different sizes of covers are provided in
the kitpack. Install the two larger covers on
the rear brackets and the smaller covers on
the front brackets.
Retaining Block
Swivel Nut
Flat Washer
Lock Nut
2.9
Cover
Bracket
TORX Screws
