5.
At each bracket, insert two swivel nuts into the
captive holes from above.
6.
Insert the appropriate TORX flat-head screws into
each bracket’s swivel nuts:
If you DID NOT install spacers in Step 4:
Insert
1
⁄
4
"-20 x 2" TORX screws into the bracket’s
swivel nuts.
If you DID install spacers in Step 4:
Insert
1
⁄
4
"-20 x 2
1
⁄
2
" TORX screws into the bracket’s
swivel nuts.
54-0208-01
2.8
TracVision A5 Installation Guide
Bracket
Cover
Roof Rack Crossbar
Retaining Block
Rubber Cushions
Swivel Nuts
Swivel Nuts
Rubber Cushions
Flat Washers
Lock Nuts
1/4"-20 x 2" TORX Screws
Securing the Brackets to the Crossbars
Bracket
Swivel Nuts
Spacer
1/4"-20 x 2-1/2"
TORX Screws
If you installed extra spacers in Step 4, and
there is still less than 1" of space between
the antenna and the roof, KVH recommends
that you either use the roof mount option or
replace the roof rack with an aftermarket
model that offers greater clearance. If the
antenna is mounted too low, it may strike
the roof when the vehicle is in motion.
If Spacers Are Installed
