2.
The bottom of the antenna should rest a
minimum of 1" above the vehicle’s roof. If the
antenna’s base is less than 1" from the roof, you
will need to add a spacer under each bracket to
raise the antenna higher. If spacers are needed,
follow the steps below to install a spacer under
each bracket:
a.
Remove the #8-32 x
3
⁄
8
" screws and washers
securing the factory-installed plastic spacer to
the metal bracket.
b. Insert a second spacer from the kitpack
between the original spacer and the bracket.
Secure both spacers to the bracket using the
#8-32 x 1" screws supplied in the kitpack and
the original washers that you removed in
Step a.
54-0208-01
2.11
Installing the Antenna
Bracket
New Spacer
Flat Washer
Lock Washer
#8-32 x 1" Screw
Factory-installed
Spacer
Adding a Second Spacer to the Bracket (If Needed)
