54-0208-01
4.12
TracVision A5 Installation Guide
2.
Press and hold the remote control’s component
button (for example, TV).
3.
At the same time, press the MUTE button for two
seconds.
4.
Release both buttons.
The component button should light and remain
lit. If it doesn’t remain lit, follow Steps 2 through
4 above.
5.
Using the remote control’s numeric keypad, enter
a device code.
6.
After entering a code, press the remote control’s
PWR button to test it. The correct code will turn
the component on and off. If several codes are
listed for the component’s type and brand, try
each of them until you find the code that turns
the component on/off. If none of these codes
work, try the code scanning method described on
page 4.10.
7.
Press the component button again to lock in the
code (in this example, the TV button).
4-6
Activating the Receiver
Before the user can start watching satellite TV via the
TracVision A5, the receiver must be activated. To
activate the receiver, the user needs to follow the
steps below:
1.
Call KVH’s Activation Department at:
1-866-551-8004
(24 hours a day, 7 days a week)
2.
After activation is complete, KVH’s Activation
Department will provide an access card number,
receiver ID number, Hughes serial number, and
model number. Enter these numbers in the
associated boxes on the red Activation Card.
The user must have the system serial
numbers handy when calling to activate.
The serial numbers are noted on the red
Activation Card. The receiver cannot be
activated without these numbers.
